In the Box
1x Screen Protector
1x Alignment Tool
1x Scraper
1x Film Removal Stick
1x Protector Application Kit*
*Protector Application Kit contains: 1x Screen Cleaning Wipe, 1x Screen Cloth, 1x Dust Removal Sticker.
Specs
Material:
Tempered glass
Weight:
2.9g (0.1oz)
Dimensions:
39.4×61.2×0.9mm (1.55×2.4×0.03in)
How to Use
Installation
- Clean the screen using the screen cleaning wipe and screen cloth. Use the dust removal sticker to ensure the screen is clear of dirt.
- Position the alignment tool in line with the camera screen.
- Remove the film from the screen protector. Position the screen protector over the screen using the alignment tool, aligning the “Insta360” end of the screen protector with the “Insta360” end of the camera screen. Slowly move the screen towards the protector until it is covered, then remove the alignment tool. Avoid pressing down on the middle of the screen protector, as it could trap air bubbles underneath.
- Scrape from the lens end of the screen protector towards the “Insta360” end until the air bubbles are completely removed.
*Notes
- When removing air bubbles, scrape them from the lens end of the screen protector towards the “Insta360” end to prevent air bubbles from forming.
- Do not reinstall the same screen protector. Dust that has collected on it may cause air bubbles and reduce adhesiveness.
- If the screen protector moves during installation, use the film removal stick to remove it and repeat the steps above. Do not completely remove the installed screen protector.
